Page 62 of 62

Re: XT-IDE on PCjr

PostPosted: Sat Mar 29, 2014 10:35 pm
by Trixter
I tested mine with my jrIDE before I released it but maybe I missed something. All the code does (the source is there, you can check) is switch the drive number to 80 (C:), 81 (D:) etc. and just work with track 0 sector 0 as always. It should work...

When I get my jrIDE system setup again I can take a look at it.

Re: XT-IDE on PCjr

PostPosted: Sun Mar 30, 2014 9:29 am
by Maximillion95
Now it did work when I made the initial 6.22 boot disk in my AT, I was able to boot the Jr with it just fine.

Re: XT-IDE on PCjr

PostPosted: Mon Mar 31, 2014 7:51 am
by jmetal88
Hmm, maybe I should try installing DOS 5 or 6.22 on my jrIDE sometime to see how it goes. I'm currently running Compaq DOS 3.31.

Re: XT-IDE on PCjr

PostPosted: Mon Mar 31, 2014 7:58 am
by Brutman
This thread is getting obnoxiously large. I'm encouraging anybody with a new "tech support" request to start a new thread. (And after a few days on inactivity in this thread, I'm going to close it.)

We've gone all of the way from initially grafting on an XT-IDE card to a Jr using a complete hack to prototype sidecars, and now two production runs of sidecars. That's pretty good for a single thread. ; - 0

Re: XT-IDE on PCjr

PostPosted: Mon Mar 31, 2014 8:51 am
by jmetal88
Brutman wrote:This thread is getting obnoxiously large. I'm encouraging anybody with a new "tech support" request to start a new thread. (And after a few days on inactivity in this thread, I'm going to close it.)

We've gone all of the way from initially grafting on an XT-IDE card to a Jr using a complete hack to prototype sidecars, and now two production runs of sidecars. That's pretty good for a single thread. ; - 0


Maybe you should 'pin' a thread with a single post and info on ordering the jrIDE. Just a thought. It seems like people wanting to order recently have trouble picking Alan's user name out of the thread.

Re: XT-IDE on PCjr

PostPosted: Mon Mar 31, 2014 9:49 am
by Brutman
That is the intent.